This section describes the countermeasures for the safe operation of RTO devices

Shanghai Lihuang specializing in the production of rotary RTO, three tower RTO, CO furnace, activated carbon adsorption box, spray tower, steel slag wet dust removal treatment equipment, SNCR denitrification equipment, SCR denitrification equipment, etc., in spraying, chemical, pharmaceutical, rubber and other waste gas treatment has rich experience, welcome industry colleagues consulting and investigation. 86-021-59106016​

Key points of use of heat accumulator in RTO system

Heat accumulator is the core unit of RTO (regenerative incinerator) to realize heat storage function, which plays a crucial role in the whole RTO equipment.

Development history of regenerative combustion device RTO

Regenerative combustion device, referred to as RTO, refers to the combustion and purification treatment of industrial organic waste gas, and the use of heat accumulator to treat the treatment of waste gas for heat exchange and heating, after purification of exhaust gas for heat exchange and cooling device.

What is the difference between RTO and RCO?

RTO technology and RCO technology are VOCs (volatile organic compounds) treatment technology, is currently widely used, good treatment effect, stable operation, low cost of mature technology.

How to clean the runner after blockage?

Field equipment daily use of compressed air, the highest pressure is 0.8mpa, due to the blockage and runner attached more closely, direct use of compressed air purging can only blow out a small amount of blockage, the effect is not good.

What should be paid attention to in transportation and use of activated carbon adsorption box

activated carbon in the transportation process, shall not be dragged with iron hook, should prevent mixed with hard substances, not strong vibration, friction, stepping, smashing, strictly prohibited throwing, should be lightly unloaded, in order to reduce the carbon particle breakage, affect the use.

Why is the main RTO device odd number of chambers?

Generally, the VOCs removal rate of even RTO is only more than 95%, while the VOCs removal rate of odd RTO can reach more than 99%. Therefore, the current domestic mainstream RTO waste gas treatment equipment is generally odd number of chambers.

Analysis and improvement measures of blocking material in RTO incinerator in pharmaceutical industry

Lihuang Group checked and analyzed the blockage of RTO system. According to the preliminary discussion, there are a lot of water soluble salts in the plug, among which the proportion of salt at the induced draft fan is relatively high, and the salt at the entrance of the RTO system is relatively low.

What is SCR and When Do I Use it?

Selective Catalytic Reduction (SCR) is a term used in the air pollution control industry for the process of selectively targeting a pollutant to remove that pollutant from an exhaust stream. The most common pollutant that is controlled through a SCR process is nitrogen oxide (NOx). While there are many catalysts that can selectively target a number of compounds, the content of this blog will focus on SCR technologies for the reduction of NOx.